The Building of Russo Park at Louisiana

[Cajun90]

If you look at the far camera shot you will see a gap in the first level on the left hand side. There is a similar gap at the same location on the first base side. These are the two locations where they will get material and equipment in and out. I suspect that the seating areas will be precast if concrete ir prefabricated if metal. These locations will be where they get the seating modules in. I suspect they will ne put in place with fork lifts. I also suspect they will be aluminum. It will be a tight working soace when that happens.

Schedule called for pre-cast concrete runners on steel supports with aluminum risers (hybrid system).

[HelmutVII]

Schedule called for pre-cast concrete runners on steel supports with aluminum risers (hybrid system).

That makes sense. Smaller lighter pieces that can be handled with a fork lift.

[LaCajunsFan]

Schedule called for pre-cast concrete runners on steel supports with aluminum risers (hybrid system).

Yes, that's part I was trying to remember. Thanks.

That makes sense. Smaller lighter pieces that can be handled with a fork lift.

Yes, I can see that happening easier now.

Thanks guys.

[CajunAmos]

A behind the stadium view from today. It's a little dark due to the overhead sun.

[Stealth]

touche'

[Ragin4U]

A behind the stadium view from today. It's a little dark due to the overhead sun.

Thats a nice shot to show the scale of the thing. Very nice.

[HelmutVII]

Lots of work going on this morning.

[HelmutVII]

Spraying insulation on the ceiling of the second level today. Guy in full body PPE stopped about 4:30.

[CajunAlum10]

Spraying insulation on the ceiling of the second level today. Guy in full body PPE stopped about 4:30.

Yea, I went by the field today and watched for a bit. Didn't notice till I got back to the office but my truck was covered in tiny specs that don't come off easy. It's def the insulation spray that prob carried in the wind. F me.

[HelmutVII]

Yea, I went by the field today and watched for a bit. Didn't notice till I got back to the office but my truck was covered in tiny specs that don't come off easy. It's def the insulation spray that prob carried in the wind. F me.

There was a reason he was wearing full body PPE. Might have a hard time getting that off. Might need to use clay bar to get it off.